The choice of the ring size can be a delicate moment when buying on a website, to facilitate this, PREFACE BIJOUX gives you some tips:
Measure the widest part of your finger.
Preferably, avoid any measurements during the day if your fingers tend to swell.
In case of intermediate size, choose the largest size.
Measure using one of your ring:
Make sure that your ring reference is the same finger ring that you want to buy.
Using a millimeter ruler, measure the inside diameter of your ring, and refer to the table below.
Measure your finger circumference:
You can measure your finger circumference with a tape measure or a twine.
Mark a first line on your starting point, then wrap your measuring tool around your finger and note the closing point.
Make sure that your measuring tool is not too tight or too mobile.
Finally, read the size in millimeters and refer to the table below.
Always choose the largest size if there is any doubt between two measurements.
In the description of each bracelet we indicate the total length of the bracelet; Your wrist should be less than this dimension.
Measure your wrist:
To measure your wrist, take a tape measure or a single twine and wrap it at the base of your hand, without too much tightening. Mark the meeting point of the ribbon and measure the length. For ease, we advise you to add about 2cm.
Measure your hand is also important, measure your palm size as shown below:
Then refer to the table of correspondences below:
For the open bangle, refer to your wrist size, because you will retract it by the wrist. Open bracelets are also slightly adjustable, so do not choose them too large.
The necklaces and chains size is expressed in centimeter on each article description and corresponds to the total length. Take a tape measure or a twine and measure your neck strap to get your necklace size.
Opt sizes between 38 and 42cm to wear a choker.
To obtain a looser necklace, choose a size between 42 and 50cm.
To wear a long necklace, choose lengths from 60cm.